How To Change Thermostat In Ford Aspire How To Change Thermostat In 99 Ford P/u 4.2 Triton Engine?

How to change thermostat in 99 ford p/u 4.2 triton engine? - how to change thermostat in ford aspire

First, here is where it is;

http://repairguide.autozone.com/znetrgs/ ...

Here are the rest;

1. Disconnect the negative cable from the battery.

2. Let engine cool, drain the cooling system connected to a lower level of the housing.

3. 2 Remove the screws on the homepage of water retention and slide the cover with the hose on one side connected.

4. Remove the thermostat and gasket.

To install:

5. Clean the joint surfaces.

6. Install the thermostat with the bridge (opposite the spring) inside the elbow connector. Make sure the notch is correctly positioned.

7. Coat of new homes Board Millh sealant resistant to water and position on the fitting out of the water. Make sure the notch is correctly positioned.

8. Place the water port on the underside of the intake manifold and install the 2 screws. Tighten the screws to 103 inch pounds. (12 Nm).

9. Fill the engine cooling circuit.

10. Connect the negative cable from the battery.

11. Start the engine and allow it to reach normal operating temperature, while the detection of refrigerant leaks.

12. Road test the vehicle and verify proper operation of the engine.

13. Check the refrigerant level and adjust if necessary.